![]() Making sense of generating G-code for turning operations from a drawing therefore takes a bit of work in DeskCNC, and ideally, needs a CAM package such as Dolphin Partmaster that is able to generate G-code for both lathe and mill operations. Firstly, although there is some support within the DeskCNC system for installing a spindle encoder that would allow threading to be performed, the DeskCNC system is primarily aimed at driving a mill one consequence of this is that there is no support within its CAM functions for turning operations. There are good reasons for this change in approach. I chose to use Mach 3 as the control software for this conversion, in place of the DeskCNC system that I have previously used for my Taig mill conversion and the earlier X3 mill conversion. In this third article, I will describe the final pieces of the jigsaw as far as the constructional phases go - building the stepper motor drive electronics, and installing spindle sensor and E-stop circuitry. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |